2008 Mack CTP Problems, Complaints & Recalls

Source: NHTSA · Updated Oct 23, 2007 · 0 owner complaints analyzed

Compared with other CTP years
Not enough data 1st of 3 for complaints
NHTSA crash rating
Not rated

NHTSA has received no owner complaints about the 2008 Mack CTP so far. There are 2 safety recalls covering this model year.

Complaints are unverified owner reports and are not adjusted for sales volume.

Compare with another car

2008 Mack CTP recalls (2)

Tap a recall to see the problem, the risk and the fix.

Trailer hitches:fifth wheel assemblyOct 23, 2007 · NHTSA campaign 07V497000 · 950 vehicles

Problem: On certain trucks equipped with a saf holland simplex fifth wheel, the lever arm pivot bolt may have been over tightened. An over tightened pivot bolt can distort the pivot bolt spacer sleeve, which may prevent the fifth wheel latch jaw from closing and latching securely around the trailer king pin.

Risk: There is a possibility that the pivot bolt can become loose without the driver's knowledge. When this occurs, the driver could drive away and the trailer could become disengaged, increasing the risk of a crash.

Fix: Dealers will replace the pivot bolt and sleeve with a hex head shoulder bolt and washer free of charge. The recall began on january 28, 2008. Owners may contact mack trucks at 1-800-528-6586.

Parking brakeAug 15, 2007 · NHTSA campaign 07V360000 · 18,805 vehicles

Problem: On certain trucks equipped with bendix sr-7 spring brake modulating valves, the internal rubber check valve may leak causing a delay in the application of the spring brakes to park the vehicle after the operator pulls the dash valve button.

Risk: This could delay or failure in applying the parking brakes which could result in a vehicle roll away, increasing the risk of a crash.

Fix: Mack is working with bendix to repair these vehicles (please see 07e037). Bendix will install a check valve repair kit for the affected sr-7 spring brake modulating valve free of charge. The recall began on january 10, 2008. Owners may contact bendix at 1-440-329-9000 or mack at 1-800-528-6586.

To see whether a specific car still has an open recall, enter its VIN on NHTSA's official recall lookup. You can also decode a VIN here.

Other Mack CTP years

← 2007 CTP

YearComplaintsRecalls
200802
2007 CTP06
2006 CTP04

See all Mack CTP problems by year, every Mack model, or the VIN decoder.

Embed this 2008 Mack CTP badge on your site

Copy this code into your blog or forum post. It shows live complaint and recall counts and links back here.

Frequently asked questions

What are the most common problems with the 2008 Mack CTP?

NHTSA has no owner complaints on file yet.

Was there a recall on the 2008 Mack CTP?

Yes, 2 safety recalls. Enter your VIN at NHTSA.gov to check whether the repairs were done on your car.

Was the 2008 Mack CTP a good year?

Complaint data can't fully answer that, because counts aren't adjusted for sales. Compared with other CTP model years, the 2008 has too little data to compare. Always get a pre-purchase inspection and check the VIN for open recalls.