2016 Mack Titan (td) Problems, Complaints & Recalls

Source: NHTSA · Updated Apr 4, 2022 · 0 owner complaints analyzed

Compared with other Titan (td) years
Not enough data 1st of 6 for complaints
NHTSA crash rating
Not rated

NHTSA has received no owner complaints about the 2016 Mack Titan (td) so far. There are 2 safety recalls covering this model year. NHTSA has opened 1 defect investigation involving it.

Complaints are unverified owner reports and are not adjusted for sales volume.

Compare with another car

2016 Mack Titan (td) recalls (2)

Tap a recall to see the problem, the risk and the fix.

SteeringDo not driveMar 16, 2016 · NHTSA campaign 16V156000 · 75 vehicles

Problem: Mack Trucks, Inc. (Mack) is recalling certain model year 2016-2017 Titan vehicles manufactured from February 25, 2015, through February 12, 2016. The bolt connecting the upper steering shaft to the lower steering shaft may not properly secure the upper steering shaft, which can lead to separation of the steering shaft.

Risk: Separation of the steering shaft will result in complete loss of steering which may lead to a vehicle crash.

Fix: Mack strongly recommends that the affected vehicles not be driven until the interim remedy is applied. An interim notice was sent to Mack owners on March 21, 2016, and an interim repair is available now. A second notice was mailed on May 12, 2016. The final remedy is now available. Both remedies will be free of charge. Owners may contact Mack customer service at 1-877-800-4945 opt #1. Mack's number for this recall is SC0401.

Power train:driveline:driveshaftFeb 19, 2016 · NHTSA campaign 16V099000 · 33,981 vehicles

Problem: Mack Trucks, Inc. (Mack) is recalling certain model year 2012-2016 Granite (GU), Pinnacle (CHU, CXU), TerraPro (LEU, MRU), Titan (TD), and LR trucks manufactured from September 1, 2011, through September 8, 2015. The cap nut that retains the interaxle driveshaft yoke to the rear axle input shaft may loosen.

Risk: If he cap nut loosens and falls off, the yoke can separate from the axle input shaft and allow the drive shaft to disconnect, increasing the risk of a crash.

Fix: Mack will notify owners, and dealers will replace the cap nut. The input shaft threads will be inspected for damage. Any damaged input shaft will be replaced. These repairs will be performed free of charge. An interim notice was sent to owners on April 25, 2016. The recall began on June 7, 2016. Owners may contact Mack customer service at 1-610-709-2131. Mack's recall campaign number for this recall is SC0399.

To see whether a specific car still has an open recall, enter its VIN on NHTSA's official recall lookup. You can also decode a VIN here.

NHTSA defect investigations

  • mDrive Transmission Failure to Disengage (PE20005) — opened Apr 28, 2020, closed Apr 4, 2022.

Other Mack Titan (td) years

← 2015 Titan (td) · 2017 Titan (td) →

See all Mack Titan (td) problems by year, every Mack model, or the VIN decoder.

Embed this 2016 Mack Titan (td) badge on your site

Copy this code into your blog or forum post. It shows live complaint and recall counts and links back here.

Frequently asked questions

What are the most common problems with the 2016 Mack Titan (td)?

NHTSA has no owner complaints on file yet.

Was there a recall on the 2016 Mack Titan (td)?

Yes, 2 safety recalls. Enter your VIN at NHTSA.gov to check whether the repairs were done on your car.

Was the 2016 Mack Titan (td) a good year?

Complaint data can't fully answer that, because counts aren't adjusted for sales. Compared with other Titan (td) model years, the 2016 has too little data to compare. Always get a pre-purchase inspection and check the VIN for open recalls.