2012 Winnebago ERA Problems, Complaints & Recalls
- Compared with other ERA years
- Not enough data 8th of 16 for complaints
- Safety recalls
- 8 recalls: check your VIN
- NHTSA crash rating
- Not rated
NHTSA has received no owner complaints about the 2012 Winnebago ERA so far. There are 8 safety recalls covering this model year.
- 0owner complaints
- 8safety recalls
- 0NHTSA investigations
- 0complaints mentioning a crash
Complaints are unverified owner reports and are not adjusted for sales volume.
2012 Winnebago ERA recalls (8)
Tap a recall to see the problem, the risk and the fix.
Seat belts:front:anchorage
Problem: Winnebago Industries, Inc (Winnebago) is recalling certain 2012-2021 Era 170X vehicles. The weld nut was installed on the wrong side of the bracket where the shoulder belt attaches, reducing the retention strength of the seat belt.
Risk: In the event of a crash, the shoulder belt upper anchorage may not provide adequate protection to the passenger, increasing the risk of injury.
Fix: Winnebago will notify owners, and dealers will coordinate the inspection of affected units and the installation of a serrated flange nut in the intended weld nut location, free of charge. The recall is expected to begin December 21, 2020. Owners may contact Winnebago Customer Care at 1-800-537-1885.
Equipment
Problem: Winnebago Industries, Inc. (Winnebago) is recalling certain 2012-2018 Winnebago ERA motorhomes. The overhead cabinet shelf may have been improperly attached, allowing the cabinet face to detach and fall into the cab area.
Risk: If the cabinet shelf detaches, contents from the cabinet may hit and/or distract the driver, increasing the risk of injury or a crash.
Fix: Winnebago will notify owners, and dealers will install two support brackets, additional screws, and a maximum capacity warning label, free of charge. The recall began February 27, 2019. Owners may contact Winnebago customer service at 1-641-585-6939 or 1-800-537-1885.
Equipment:recreational vehicle/trailer:lpg systems:lines and fittings
Problem: Winnebago Industries, Inc. (Winnebago) 2012-2013 Winnebago Era, View, and Via motorhomes and Itasca Navion and Reyo motorhomes. The high pressure liquid propane hoses may harden at the crimp fitting, possibly resulting in a propane leak.
Risk: A propane leak in the presence of an ignition source can increase the risk of a fire.
Fix: Winnebago will notify owners, and dealers will inspect the propane hose, replacing it as necessary, free of charge. The recall began September 17, 2018. Owners may contact Winnebago customer service at 1-641-585-6939 or 1-800-537-1885. Winnebago's number for this recall is 151.
Equipment:other:labels
Problem: Winnebago Industries, Inc. (Winnebago) is recalling certain model year 2012-2016 Winnebago Era recreational vehicles manufactured November 11, 2010, to July 20, 2015. The certification label affixed to the vehicles provide an incorrect front tire inflation pressure. Accordingly, these vehicles fail to comply with the requirements of 49 CFR Part 567, "Certification."
Risk: Incorrect tire pressure information could cause an owner or operator to under or over inflate the tires, increasing the risk of a tire failure and a crash.
Fix: Winnebago will notify owners, and dealers will provide new certification labels with the correct tire inflation pressure specifications, free of charge. The recall began on September 18, 2015. Owners may contact Winnebago customer service at 1-641-585-3535.
Electrical system:wiring:fuses and circuit breakers
Problem: Winnebago is recalling certain model year 2009-2013 model Era motorhomes, 2010-2013 Via and Itasca Reyo motorhomes, and 2011-2013 View and Itasca Navion motorhomes; manufactured November 13, 2007, through August 20, 2012. The proper fuses were not installed for the refrigerator circuits.
Risk: Without the proper fuse, heat can build which could lead to a vehicle fire.
Fix: Winnebago will notify owners, and dealers will replace the fuses. The recall began on December 21, 2012. Consumers may contact Winnebago Industries owner relations at 1-641-585-6939.
Equipment:recreational vehicle/trailer:lpg systems:lines and fittings
Problem: Winnebago is recalling certain model year 2012-2013 Winnebago and Itasca motor homes. A cutting machine may have scored the copper propane tubing resulting in unknown long-term reliability.
Risk: If the copper tubing fails, propane can escape leading to a fire or explosion which can result in property damage, personal injury, or death.
Fix: Winnebago will notify owners, and dealers will replace the copper tubing, free of charge. The recall began on September 6, 2012. Owners may contact Winnebago Industries Owner Relations at 1-641-585-6939.
Suspension:rear:springs
Problem: Winnebago is recalling certain model year 2012 era motor homes, manufactured from july 25, 2011, through august 4, 2011and built on sprinter/daimler chassis. The supplier of the rear springs rolled the spring eye diameter out of tolerance during production, and then corrected the diameter without heating the parts. This could potentially lead to a crack of the spring eye over time.
Risk: If a spring eye were to crack, the rear spring could collapse, suddenly upsetting the vehicles handling, which could increase the risk of a crash.
Fix: Winnebago is working with sprinter/daimler to notify owners. Sprinter/daimler is handling the remedy for this campaign, please see 11v-323. Sprinter/daimler dealers will replace the rear springs as necessary free of charge. The safety recall began on november 30, 2011. Owners may contact sprinter at 1-877-762-8267.
Equipment:other:labels
Problem: Winnebago is recalling certain model year 2012 era motor homes manufactured from november 11, 2010, through july 13, 2011, for failing to comply with the requirements of federal motor vehicle safety standard no. 120, "tire selection and rims for motor vehicles other than passenger cars." these vehicles are equipped with the wrong vehicle weight label.
Risk: Noncompliance issue - weight information on the wrong format label.
Fix: Owners will be provided with new labels and installation instructions. At the customer's option, a dealer can perform the installation for them. This service will be performed free of charge. The safety recall began on august 19, 2011. Owners may contact winnebago at 1-641-585-6939.
To see whether a specific car still has an open recall, enter its VIN on NHTSA's official recall lookup. You can also decode a VIN here.
Other Winnebago ERA years
| Year | Complaints | Recalls |
|---|---|---|
| 2024 ERA | 1 | 1 |
| 2023 ERA | 0 | 2 |
| 2022 ERA | 1 | 2 |
| 2021 ERA | 0 | 3 |
| 2020 ERA | 0 | 4 |
| 2019 ERA | 0 | 3 |
| 2018 ERA | 0 | 5 |
| 2017 ERA | 2 | 6 |
| 2016 ERA | 4 | 8 |
| 2015 ERA | 2 | 8 |
| 2014 ERA | 1 | 6 |
| 2013 ERA | 1 | 7 |
| 2012 | 0 | 8 |
| 2011 ERA | 0 | 1 |
| 2010 ERA | 0 | 1 |
| 2009 ERA | 0 | 2 |
See all Winnebago ERA problems by year, every Winnebago model, or the VIN decoder.
Similar Winnebago models
Embed this 2012 Winnebago ERA badge on your site
Copy this code into your blog or forum post. It shows live complaint and recall counts and links back here.
Frequently asked questions
What are the most common problems with the 2012 Winnebago ERA?
NHTSA has no owner complaints on file yet.
Was there a recall on the 2012 Winnebago ERA?
Yes, 8 safety recalls. Enter your VIN at NHTSA.gov to check whether the repairs were done on your car.
Was the 2012 Winnebago ERA a good year?
Complaint data can't fully answer that, because counts aren't adjusted for sales. Compared with other ERA model years, the 2012 has too little data to compare. Always get a pre-purchase inspection and check the VIN for open recalls.