2011 E-One Quest Problems, Complaints & Recalls

Source: NHTSA · Updated Dec 1, 2011 · 0 owner complaints analyzed

Compared with other Quest years
Not enough data 1st of 9 for complaints
NHTSA crash rating
Not rated

NHTSA has received no owner complaints about the 2011 E-One Quest so far. There are 2 safety recalls covering this model year.

Complaints are unverified owner reports and are not adjusted for sales volume.

Compare with another car

2011 E-One Quest recalls (2)

Tap a recall to see the problem, the risk and the fix.

Electronic stability control (esc)Dec 1, 2011 · NHTSA campaign 11V564000 · 220 vehicles

Problem: E-one is recalling certain model year 2008 through 2011 cyclone ii, typhoon, and quest vehicles manufactured from may 1, 2008, through november 28, 2011, and equipped with meritor wabco electronic stability control (esc) modules. Under certain road and driving conditions, vehicle body roll and road inclination characteristics may adversely affect the slip angle calculation of the electronic stability control (esc) system. This might cause the esc to perceive an over steering situation and therefore apply the outer wheel brake on the front axle until the vehicle is perceived to be stable.

Risk: If the driver is slow to react during this esc intervention, the vehicle may deviate from the intended line of travel, increasing the risk of a crash.

Fix: E-one will notify owners and is working with meritor wabco to replace the control module free of charge. The safety recall began on december 16, 2011. Owners may contact e-one customer service at 1-800-627-5050 or meritor on track customer service at 1-866-668-7221.

Engine and engine coolingAug 17, 2011 · NHTSA campaign 11V443000 · 33 vehicles

Problem: E-ONE IS RECALLING CERTAIN MODEL YEAR 2010 AND 2011 TYPHOON AND CYCLONE II AND MODEL YEAR 2011 TRADITION AND QUEST FIRE FIGHTING CHASSIS MANUFACTURED FROM NOVEMBER 24, 2010, THROUGH JULY 13, 2011, EQUIPPED WITH A CUMMINS ISB, ISL, ISC, or ISX DIESEL ENGINE. THE V-BAND CLAMP ASSEMBLY, PART NUMBERS Q187684, Q187685, AND Q187686, USED TO CONNECT THE INLET AND OUTLET CONE SECTIONS TO THE DIESEL OXIDATION CATALYST (DOC)/DIESEL PARTICULATE FILTER (DPF) INCLUDE A T-BOLT WHICH CAN FRACTURE AND FAIL WHEN SUBJECTED TO STRESS OR LOAD. A FRACTURE OR FAILURE OF THE T-BOLT MAY CAUSE THE CLAMP TO LOOSEN AND THE INLET OR OUTLET SECTIONS ATTACHED TO THE DOC/DPF HOUSING TO DISCONNECT.

Risk: This could result in asphyxiation or carbon monoxide poisoning. The heat build up from the exhaust can also result in a fire. If both clamps fail, there is a risk in some applications that the doc/dpf housing may detach completely, creating a road hazard.

Fix: E-one is working with cummins to identify and notify owners of the recall campaign. Repairs will be performed by authorized cummins dealers free of charge. The safety recall began on october 10, 2011. Owners may contact cummins at 1-812-377-5000 or e-one at 1-352-861-3223.

To see whether a specific car still has an open recall, enter its VIN on NHTSA's official recall lookup. You can also decode a VIN here.

Other E-One Quest years

← 2010 Quest · 2013 Quest →

See all E-One Quest problems by year, every E-One model, or the VIN decoder.

Embed this 2011 E-One Quest badge on your site

Copy this code into your blog or forum post. It shows live complaint and recall counts and links back here.

Frequently asked questions

What are the most common problems with the 2011 E-One Quest?

NHTSA has no owner complaints on file yet.

Was there a recall on the 2011 E-One Quest?

Yes, 2 safety recalls. Enter your VIN at NHTSA.gov to check whether the repairs were done on your car.

Was the 2011 E-One Quest a good year?

Complaint data can't fully answer that, because counts aren't adjusted for sales. Compared with other Quest model years, the 2011 has too little data to compare. Always get a pre-purchase inspection and check the VIN for open recalls.