2014 Mack Pinnacle (chu) Problems, Complaints & Recalls
- Compared with other Pinnacle (chu) years
- Not enough data 2nd of 12 for complaints
- Safety recalls
- 4 recalls: check your VIN
- NHTSA crash rating
- Not rated
NHTSA has received no owner complaints about the 2014 Mack Pinnacle (chu) so far. There are 4 safety recalls covering this model year. NHTSA has opened 1 defect investigation involving it.
- 0owner complaints
- 4safety recalls
- 1NHTSA investigations
- 0complaints mentioning a crash
Complaints are unverified owner reports and are not adjusted for sales volume.
2014 Mack Pinnacle (chu) recalls (4)
Tap a recall to see the problem, the risk and the fix.
Suspension:front:hub
Problem: Mack Trucks, Inc. (Mack) is recalling certain model year 2012, 2014-2015 and 2017 Granite (GU), 2012-2017 Pinnacle (CHU, CXU), and 2013-2015 and 2017 Titan (TD) trucks manufactured January 7, 2011, to September 29, 2016. The affected vehicles were built with front wheel hubs that cannot support the gross axle weight rating of the front axle.
Risk: Overloaded front wheel hubs can result in premature failure of the hubs, bearings, and the related components, which can cause the front hub assembly to separate from the front axle. Because of this, the driver may lose control of the vehicle or parts may be dropped on the road, increasing the risk of a crash.
Fix: Mack will notify owners, and dealers will replace the hub assemblies, free of charge. The recall began on February 16, 2017. Owners may contact Mack customer service at 1-800-866-1177. Mack's number for this recall is SC0406.
Power train:driveline:driveshaft
Problem: Mack Trucks, Inc. (Mack) is recalling certain model year 2012-2016 Granite (GU), Pinnacle (CHU, CXU), TerraPro (LEU, MRU), Titan (TD), and LR trucks manufactured from September 1, 2011, through September 8, 2015. The cap nut that retains the interaxle driveshaft yoke to the rear axle input shaft may loosen.
Risk: If he cap nut loosens and falls off, the yoke can separate from the axle input shaft and allow the drive shaft to disconnect, increasing the risk of a crash.
Fix: Mack will notify owners, and dealers will replace the cap nut. The input shaft threads will be inspected for damage. Any damaged input shaft will be replaced. These repairs will be performed free of charge. An interim notice was sent to owners on April 25, 2016. The recall began on June 7, 2016. Owners may contact Mack customer service at 1-610-709-2131. Mack's recall campaign number for this recall is SC0399.
Trailer hitches:fifth wheel assembly
Problem: Mack Trucks, Inc. (Mack) is recalling certain model year 2011-2014 Pinnacle (CHU and CXU) trucks manufactured September 10, 2010, to June 17, 2013. The affected trucks are equipped with Fontaine Ultra LT Fifth Wheel connectors, which, due to cumulative damage to the fifth wheel and its locking mechanism, have a locking mechanism that may fail to operate or to properly engage.
Risk: If the fifth wheel and locking mechanism are sufficiently damaged, the locking mechanism may fail to operate as intended and the trailer may unexpectedly detach from the tractor, increasing the risk of a crash.
Fix: Mack will notify owners, and Fontaine dealers will replace the fifth wheel with an Ultra NT model fifth wheel, free of charge. The recall began on November 18, 2015. Owners may contact Mack customer service at 1-800-866-1177. Mack's number for this recall is SC0395.
Electrical system:wiring; service brakes, air:supply:hoses, lines/piping, and fittings
Problem: Mack Trucks, Inc. (Mack) is recalling certain model year 2013 and 2015 Titan (TD), model year 2014 and 2015 Pinnacle (CHU), and model years 2009-2010, 2012, and 2014-2016 Granite (GU) trucks. The chassis harness and air lines may not be properly clipped to the crossmember, which can allow the cables and air lines to fall and get twisted in the driveline.
Risk: If the electrical cables and air lines were to fall and get tangled in the driveline, it could affect the electrical system and braking system, increasing the risk of a vehicle crash.
Fix: Mack will notify owners, and dealers will inspect the vehicles and properly clip the harness and air lines, free of charge. The recall began on September 30, 2015. Owners may contact Mack customer service at 1-800-528-6586. Mack's number for this recall is SC0393.
To see whether a specific car still has an open recall, enter its VIN on NHTSA's official recall lookup. You can also decode a VIN here.
NHTSA defect investigations
- mDrive Transmission Failure to Disengage (PE20005) — opened Apr 28, 2020, closed Apr 4, 2022.
Other Mack Pinnacle (chu) years
← 2013 Pinnacle (chu) · 2015 Pinnacle (chu) →
See all Mack Pinnacle (chu) problems by year, every Mack model, or the VIN decoder.
Embed this 2014 Mack Pinnacle (chu) badge on your site
Copy this code into your blog or forum post. It shows live complaint and recall counts and links back here.
Frequently asked questions
What are the most common problems with the 2014 Mack Pinnacle (chu)?
NHTSA has no owner complaints on file yet.
Was there a recall on the 2014 Mack Pinnacle (chu)?
Yes, 4 safety recalls. Enter your VIN at NHTSA.gov to check whether the repairs were done on your car.
Was the 2014 Mack Pinnacle (chu) a good year?
Complaint data can't fully answer that, because counts aren't adjusted for sales. Compared with other Pinnacle (chu) model years, the 2014 has too little data to compare. Always get a pre-purchase inspection and check the VIN for open recalls.