1998 Ford Explorer Vehicle Speed Control Problems

Problem: Ford is recalling model years 1995-2003 windstar, 2000-2003 excursion diesel, 1993-1997 and 1999-2003 f-250 sd through f-550 sd diesel, 1992-2003 e-150 through e-550, 1995-2002 explorer, 1997 and 2002 mercury mountaineer, 1995-1997 and 2001-2003 ranger, and 1994 f53 vehicles equipped with the texas instruments speed control deactivation switch (scds). The scds may leak internally and then overheat, smoke, or burn.

Risk: A vehicle fire could occur with or without the engine running.

Fix: Ford will notify owners that dealers will install a fused wiring harness in line with the scds. On 1999-2003 windstar vehicles with a leaking scds, dealers will also inspect the abs control module connector and repair as necessary. Repairs will be completed free of charge. The safety recall began on october 27, 2009. Owners may contact ford at 1-888-222-2751.

Problem: On certain trucks equipped with speed control, gasoline or natural gas engines, the speed control deactivation switch may overheat.

Risk: Overheating could result in smoke or burn and an underhood fire.

Fix: Dealers will install a fused wiring harness into the speed control system free of charge. The recall began on august 7, 2006. Owners may contact ford at 1-866-436-7332. (note: also see recalls 05v017 and 05v388)

Problem: Vehicle description: sport utility vehicles equipped with 4.0l sohc engines and still retain the original throttle body (part numbers 97jf-9e926ab or 97jf-9e926-ac). Some of the original throttle bodies installed allowed a gap between the plate and bore to be built too narrow. This reduced clearance allowed the engine deposits normally present in the throttle body to contact or bridge the gap. If the engine deposits bridged the gap between the throttle plate and bore and then hardened, on the initial application of the accelerator pedal after the engine has cooled, the operator would need to apply additional force to the accelerator pedal to break the bridge.

Risk: This could result in engine surge when the accelerator pedal breaks free.

Fix: Dealers will replace the original throttle bodies.

Problem: Vehicle description: certain 1997-1999 rhd explorer equipped with 4.0l ohv/sohc engines and cruise control built from may 29, 1996 through march 4, 1999; 1998-1999 explorer/mountaineers equipped with 4.0l ohv/sohc or 5.0l engines or 1998-1999 rangers equipped with 2.5l, 3.0l ffv/efi or 4.0l engines and cruise control built from january 5, 1998 through march 4, 1999; 1998-1999 mustangs equipped with 3.8l, 4.6l 2-valve or 4-valve engines and cruise control built from march 2, 1998 through march 4, 1999; 1999 f250/f350/f450/f550 (over 8,500 lbs.) trucks equipped with 5.4l or 6.8l engines and cruise control built from march 2, 1998 through march 4, 1999; and 1999 f-53 stripped chassis equipped with 5.4l or 6.8l engines and cruise control built from march 2, 1998 through march 4, 1999. A cruise control cable can interfere with the speed control servo pulley and not allow the throttle to return to idle when disengaging the cruise control.

Risk: If the cruise control is used and this condition is present, a stuck throttle could result, which could potentially result in a crash.

Fix: Dealers will replace the cruise control cables. At the present time, the replacement cables are not available. Customers are being advised not to use the cruise control system until a replacement can be made.