1998 Ford F-250 Problems, Complaints & Recalls

Problem: Ford is recalling certain 1997 through 2003 model year ford f-150, 2004 model year ford f-150 heritage, 1997 through 1999 model year f-250 less than 8,500 lbs. Gross vehicle weight rating (gvwr), and 2002 and 2003 lincoln blackwood vehicles manufactured from june 20, 1995, through august 4, 2004, originally sold, or currently registered in, connecticut, delaware, illinois, indiana, iowa, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia. Prolonged exposure to road deicing chemicals may cause severe corrosion of the fuel tank straps which secure the tank to the vehicle.

Risk: As a result of the corrosion, one or both straps may fail allowing the fuel lines to separate from the tank, or in some cases, causing the tank to contact the ground. Either scenario may result in a fuel leak presenting a fire hazard.

Fix: Ford will notify owners and instruct them to take their vehicles to a ford or lincoln dealer to have the fuel tank straps replaced with straps that have increased corrosion protection. Early in this campaign, if replacement straps are not available, dealers may install a cable support under the strap as an interim repair or a steel reinforcement over the existing strap as a permanent repair. Any repairs will be performed free of charge. The safety recall began on september 16, 2011. Owners may contact ford motor company customer relationship center at 1-866-436-7332. Ford's recall campaign number is 11s21

Problem: On certain trucks equipped with speed control, gasoline or natural gas engines, the speed control deactivation switch may overheat.

Risk: Overheating could result in smoke or burn and an underhood fire.

Fix: Dealers will install a fused wiring harness into the speed control system free of charge. The recall began on august 7, 2006. Owners may contact ford at 1-866-436-7332. (note: also see recalls 05v017 and 05v388)

Problem: On certain pickup trucks and sport utility vehicles equipped with speed control, the speed control deactivation switch may overheat, smoke, or burn.

Risk: A fire at the switch could occur.

Fix: By letter dated september 12, 2005, owners were instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. Owners who have had their speed control deactivated are being notified that parts will be available and advised to make an appointment to reconnect the speed control beginning in february 2006. Owners who did not have their speed control deactivated are being notified to have their system remedied beginning in february 2006. Owners are urged to avail themselves of the free disconnect service as soon as possible because of the significant risk of fire. Owners may contact ford at 1-800-392-3673. (note: also see recalls 05v017 and 06v286)

Problem: Vehicle description: bi-fuel cng pickup trucks and bi-fuel cng vans, modified by cfi control systems, inc., fail to conform to the requirements of fmvss no. 303, "fuel system integrity of compressed natural gas vehicles." the label affixed to the fuel filler door by the vehicle modifier contains the inspection date and expiration date of the cng tank. However, it does not contain the statement "see instructions on the fuel container for inspection and service life."

Risk: These vehicles do not comply with the requirements.

Fix: Owners will be provided a label with the required statement, along with instructions for affixing the label at the fuel filler door. Owner notification began november 2, 2000. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford at 1-800-392-3673.

Problem: Vehicle description: multi-purpose vehicles and light duty pickup trucks. The lug nuts on these vehicles may not create sufficient clamp load allowing wheel movement in relation to the hub/rotor mounting surface.

Risk: This can result in the loosening of lug nuts, stud fatigue failure, and the potential for a wheel separation from the vehicle, increasing the risk of a vehicle crash.

Fix: Owners of these vehicles will be receiving two notifications. The first notification, which began in may 1998, will provide an interim repair procedure until parts become available. This interim procedure can be completed by owners or their dealers. It specifies that the lug nut torque must be verified to be 100 lbs. Then the lug nuts need to be tightened an additional 1/8 to 1/4 turn more. There will be a second owner notification, which is expected to begin july 20, 1998, under which dealers will inspect the wheel studs and replace the wheel lug nuts.

Problem: Vehicle description: light duty pickup trucks and multi-purpose passenger vehicles. If the automatic transmission shift cable assembly was not fully attached to the steering column bracket, the shift cable assembly can come out of the bracket. The vehicle operator would then not be able to shift the transmission from one of the drive gear positions into the park position even though the gear shift selector would indicate "park."

Risk: The condition would not allow a disengagement of the transmission from the park position or affect proper neutral start switch operation. Unintended vehicle movement could occur if the parking brake was not set.

Fix: Dealers will make the proper attachment of the transmission shift control cable to the steering column bracket and add a tie strap to that connection.